FEYNLAB® LEVELING AID is engineered to assist with the leveling process of more difficult coating installations; such as Ceramic Plus and Heal Lite. Different protection aspects of coatings in the FEYNLAB™ line can make application a bit more challenging. It is only intended to help clear off excess coating residue ale leave the surface with a clear appearance. LEVELING AID is also compatible with other coating technology outside of the FEYNLAB chemistry family.

Product Benefits:
FEYNLAB® LEVELING AID, in addition to helping the leveling process, also acts as a ‘topper’ to FEYNLAB® coatings, leaving the surface super slick and hydrophobic.

FEYNLAB’s™ true Nano technology and bonding chemistry allows for an unparalleled level of protection since the formula penetrates further into the existing paint structure than anything else available.


Always wear respirator & gloves during application. Ensure application area is free of loose contamination.

Paint Preparation:
Thoroughly clean vehicle using FEYNLAB® PURE WASH. Follow with a topical decontamination clay treatment using FEYNLAB® PRIME. If necessary, use a ferrous iron removal product to remove all embedded iron deposits. After polishing paint to desired level, remove all polish oils using FEYNLAB® PANEL PREP to ensure optimal bonding and durability of the coating.

LEVELING AID Application Directions:
LEVELING AID is used to assist in the removal of FEYNLAB® coatings, once coatings have dried about 75%.

Using a clean microfiber towel, first apply 3-5 sprays of LEVELING AID to the towel. Then, for each section the size of half a door or a quarter of a hood, apply 3-4 more to the towel then spread evenly over the surface. The amount of product should be enough to evenly coat the area without over saturation. LEVELING AID may also be applied via MF applicator pad.

After applying, flip the towel over and buff the area clear or use another dedicated clean microfiber towel to buff clear..

Recommended Maximum Area of Application:
HALF of a door or 1/4 of a hood, then wipe off in same pattern as application.

Final Inspection:
Carefully inspect all finished panels for leftover coating residue (high spots) before moving on to the rest of the car. Commonly edges, emblems and tight spaces tend to hold remaining product. High spots are much easier to remove if you catch within a 20-40 min window after final wipe than later on.

Post Application Instructions

  • Avoid any incidental water exposure for 24 hours.
  • Avoid all chemicals including car washes for 7 days.

Climate Notes

All FEYNLAB® Coatings are subject to different dwell and curing time windows due to humidity and temperature. In General, the higher the humidity level the quicker the coating will cure. If humidity level approaches 75% or higher then consider lessening the recommended dwell and wipe times for the coating.

If possible apply coating in temperature controlled environment 10°C-30°C (50°F-85°F), with humidity as low as possible.